John Bean T 8058 Manuel D'utilisation page 50

50
5.5.-1
5.5-2
5.5-3
5.5-4
Operations
5.5 Mounting
supersingle tubeless truck tires
(over 13" wide)
1.
Hang the inner bead of the tire on the mounting clamp
(Fig.5.5-1).
2.
Position the mounting hook about 3/4" (1.5 cm) to the
inside of the rim edge and 1/2" (1 cm) away radially.
Rotate the chuck clockwise. Normally less than 1/4 of
a revolution is sufficient to mount the first bead (Fig.5.5-
2).
3.
Reattach the mounting clamp to the rim flange with the
valve after the mounting clamp, following the rotation
direction (Fig.5.5-3).
4.
Rotate the chuck clockwise until the tire is completely
mounted.
Ensure that outer bead descends into the drop center
when the clamp is opposite to the mount/demount tool
(Fig.5.5-4).
NEVER USE HAND PRESSURE TO HOLD THE TIRE
INTO THE RIM
STOP THE CHUCK BEFORE ONE COMPLETE TURN
IS MADE TO AVOID SERIOUS DAMAGE TO THE
MOUNTING CLAMP AND TO THE RIM
DO NOT INFLATE THE TIRE ON THE MACHINE. THIS
MACHINE IS NOT AN INFLATION DEVICE.
FOR INFLATION PLACE THE WHEEL IN AN
APPROVED INFLATION RESTRAINT DEVICE (IN THE
UNITED STATES OF AMERICA CONSULT O.S.H.A.
REGULATIONS CONCERNING THE PROPER
SERVICING OF TRUCK, WHEELS AND RIMS)
Operator's Manual
duplex and
John Bean T 8058