Operation - Meister MAS18V-22 Traduction Du Manuel D'utilisation Original

5451420-Akkubohrsc_man 04.12.14 10:16 Seite 45
charging process is normal and does
not represent a fault.
A battery with a considerably shortened
operating time indicates that it needs to
be replaced.
Note: The range of the battery is
influenced by the charged state, the
frequency of use, the material being
processed and the level of energy
required to do so.
A new battery only reaches full
performance capability after 5 charge
and discharge cycles.
It the range of a freshly charged battery
should drop considerably when
compared to a new one, the battery is
old and should soon be replaced by a
new one. To do this, contact the
specified service station.
The rechargeable battery is protected by
a thermo-protection fuse against
overcharging - nevertheless it should be
withdrawn from the charging unit on
expiry of the charging time. A constant
heating of charging unit and rechargeable
battery during the charging is normal and
does not represent any malfunction.
TIP! It is recommended
additionally to control the
charging process via an electrical
time-switch clock!
8 – Operation
All standard screwdriver bits, bit holders
and drills, up to a diameter of 10 mm
(not in the scope of delivery), can be
clamped in the drill chuck (7) (Fig. 4).
The machine is provided with a quick-
action drill chuck. In this way, you can
All manuals and user guides at all-guides.com
replace the accessories in manual
operation rapidly and without drill chuck
keys.
is always fixed with a left-hand thread
bolt. This is to be loosened in front
through the drill chuck (7) before a
drill chuck change. Left-hand thread
bolts can be loosened through
clockwise rotation only.
The screwdriver bits and drill bits with a
length of 50 mm can also be inserted
directly into the bit receptacle.
LED working light (5)
make working in dark areas safe. The
working light goes out when the On/Off
switch is released.
beam of light as this may result in
damage to the eyes.
Prior to start-up
Insert a wood screw gently into the
holes pre-drilled using a drill bit.
Machine screws should be started off
gently. Fit a suitable bit or socket to the
battery-powered screwdriver/drill and
place firmly against the screw.
Starting and stopping
too deep. Watch the screwing
process carefully and, if necessary,
stop early and finish the process with
The drill chuck of clockwise/
anti-clockwise rotation machines
When the unit is switched on, the
LED working light (5) also comes
on to ensure better vision and to
CAUTION! LED is laser class 1!
Do not look directly into the
Caution! Risk of over winding
caused by screwing screws in
45