Mechanical Checks; Setup And Adjustments - Corghi ERCO Série Manuel D'utilisation

•
Lubricate with grease the sliding block housings positioned under the platforms
and on the base frames;
•
Lift fixing points to the ground with 8 anchor bolts (min. recommended size ø
= 16 mm);
•
Clean all parts of the machine;
•
Proper oil level in the tank;
•
No leakage and blow-by;
•
Cylinder operation.
Carry out two or three complete cycles of lowering and lifting and check:
the lift for reaching its maximum height;
the up limit switch for proper operation;
the down limit switch for proper operation;
levelling limit switch for proper operation (both platforms should lower
simultaneously);
the buzzer/signalling light for proper operation during the final travel
WARNING: please carefully follow the instructions in the
next paragraph in order to avoid lift damage.
7.9 Testing and inspections

7.9.1 Mechanical checks

7.9.2 Hydraulic system check
7.10 Set up and adjustments
7.10.1 Check without load
115