Corghi ERCO Série Manuel D'utilisation page 103

7.4 Platform assembly and control unit positioning
Unauthorised persons are not allowed during assembly.
Take platforms to the installation site by using hoisting means with a load capacity of at least
500 kg.
To prevent the platform from dropping during transport, it should be lifted according to its
centre of gravity.
Always raise platforms by holding them on the underside of the base frames. Position the
base frames on the foundations according to the drive-on direction of the lift.
Lift platforms with auxiliary equipment by using strong ropes, slings or chains and insert the
safety blocks.
Place the control unit in the required position.
7.5 Hydraulic system connections for Lift without
mechanical safety devices (see Figure 16 - 16.1)
Connect hydraulic hoses to the fittings placed on the fixed platforms referring to the letters
shown on them;
Tighten thoroughly;
Connect hydraulic hoses to the fittings placed on the hydraulic unit referring to the letters
shown on them;
Tighten thoroughly.
103