Corghi ERCO Série Manuel D'utilisation page 100

6.5 Bumping risk
When the lift is stopped at relatively low height for operational
reasons, there is the risk of bumping against projecting parts.
6.6 Risk of vehicle falling from the lift
Vehicle falling from the lift can be caused when the vehicle is improperly placed on platforms,
and when its dimensions are incompatible with the lift or by excessive movement of the
vehicle.
In this case, immediately go away from the working area.
6.7 Slipping risks
The risk of slipping can be caused by oil or dirt on the floor
near the lift.
Keep the area under and around the lift clean. Remove all oil spills.
6.8 Electrocution risks
Avoid use of water, steam, solvent, paint in the lift area and, in particular, next to the electric
panel.
100