Location; Connecting To The Power Supply; Advices For A Correct Use Of The Equipment; Optimization Of The Cycles - Techfrost E Série Manuel D'utilisation

guards on moving parts or electrics are screwed to the cabinet. These guards avoid any form of acci-
dental contact with parts that present a risk to the user. Always respect safety standards:
• Do not touch the Chiller with wet hands or feet
• Not use the Chiller barefooted
• Do not poke screwdrivers, cutlery or other objects between the safety guards mounted on mo-
ving parts
• Before cleaning or servicing the Chiller lock-off the power supply.
Carefully follow and adhere to the instructions given in this chapter to guarantee working efficiency
and safety when the Chiller is in use.
CAUTION: When transporting or moving the Chiller to the installation site do not push or drag it, lift
it and position it on a trolley to avoid overturning.

5.3 Location

Locate the Chiller in a ventilated area distant from heat sources such as radiators, air conditioning
units, deep-fryers and ovens. Make sure the Chiller is located at a distance not less than 10 cm from
the back wall to permit a good cooling effect for the various components.
To maintain the correct internal temperature, the ambient temperature must not exceed +32°C
Adjust height and levelling using the support feet and also check the door closes.
If the Chiller is not perfectly level working efficiency and condensation flow may be affected. Remove
the PVC protective film on both sides of the Chiller.
The machine should be situated allowing adequate space around it so that proper air circulation is
assured.

5.4 Connecting to the power supply

Connect the unit only to energy sources properly earthed.
Do not damage the power cord (danger of electric accident). If it is damaged, it has to be replaced im-
mediately by a qualified electrician from the assistance centre.Install a safety switch in case of fault
currents with a specific protection for persons (30mA) on the power supply control panel.
CAUTION: the manufacturer shall not be held responsible for damage or accidents caused by ne-
gligence due to the non-observance of the recommendations and regulations given or of the local
governing standards and laws regarding electrical safety.

6 ADVICES FOR A CORRECT USE OF THE EQUIPMENT

6.1 Optimization of the cycles

PRE-COOLING
Pre-cooling is highly recommended before carrying out a chilling or rapid deep-freezing cycle to
pre-cool the cell in order to reduce working times.
CORE PROBE (optional)
The core probe, if it is present (optional), shall be properly positioned in the core of the thicker por-
tion of product. Its point shall neither come out nor touch the pan. The probe shall be cleaned before
starting any cycle, in order to prevent contaminations.
www.techfrost.com
35