Checking The Impact Force; Final Checks - Erreka DINGO Manuel De L'installateur

START UP AND PROGRAMMING
4

CHECKING THE IMPACT FORCE

F < 400N in spaces between 50 mm and 500 mm
d
F < 1400N in spaces > 500 mm
d
5

FINAL CHECKS

Following installation and programming, start up the
operator and check the devices installed.
1 Check the correct operation of the key devices (push
button and wall key, remote control).

See "Operation modes" on page 46.
2 Check the correct operation of the safety devices
(photocells-safety strips).

See "A- Detection by photocell or strip" on
page 46.
3 Place an obstacle and make the gate collide with it
in order to check operation in the event of collision.

See "B- Direct detection (built-in safety)" on
page 46.

If the system does not work correctly, find out
why and
"Troubleshooting" on page 60).
58
Installation Guide
put it right (see
1 Measure the force of the impact and compare it
to the values indicated in Standard EN12453:2000.
If the values measured are above those of the
standard, reduce the maximum force, the speed of
the gate and slowdown speed, or increase
slowdown distance.

Gate speed: A20X

Slowdown speed: A30X

Slowdown distance: A40X

Maximum force: A6XX

The control board must be programmed in a
manner which respects the values indicated in
standard EN 12453:2000, as shown in the
attached chart. The measurements must be
made in line with the method described in
standard EN 12445:2000.
• The standard indicates that at distances of
between 50 mm and 500 mm, the dynamic
force must be less than 400N. At distances of
over 500 mm, the dynamic force must be
less than 1400N.
User instruction
1 Instruct the user with regards to the use and
maintenance of the facility and provide him/her with
the instructions on use.
2 Signpost
automatically and indicating how to operate it
manually.
operation is using the remote control.
section
the gate, showing that
Where appropriate, indicate
it opens
that