Operation; Advanced Parameter Setting; Activating Automatic Closing Mode - SOMFY AXOVIA 220B RTS Manuel D'installation

Axovia 220B RTS
4) Initiate a second opening and closing cycle. The leaves close at the
same time. Once it has closed a second time, the indicator light
comes on permanently.
Attention
=
If the indicator light
=
refer to the troubleshooting guide.
=
=
1
1
1 2
1 3 3
1 4 4
=
=
Attention
The movements of the gate leaves during auto-programming are
always at a reduced speed.
The two opening/closing cycles must be complete for auto-pro-
gramming to take place. If the movement of the gate is interrupted
during auto-programming, the process is delayed and will resume
next time the gate is fully opened.
THE MOTOR IS READY TO OPERATE.
It will operate in sequential mode by default.

9. OPERATION

The motor can operate in sequential mode or automatic closing mode.
• Sequential mode: successive presses of the same remote con-
trol button will lead to the following movements: Open, Stop, Close,
Stop, Open etc.
• Automatic closing mode: pressing the programmed button of the
remote control will cause the gate to open. The gate will close au-
tomatically a er 30 seconds. If photoelectric cells are installed, any
movement in front of the cells will cause the gate to close automat-
ically a er 5 seconds.
The gate can be held in the opened position by giving a stop command
during the time delay. To close the gate, press the remote control button
again.
3-button remote control - Using the central button
• With the gate closed, pressing the central button on the remote con-
trol causes the gate to open in pedestrian mode (motorised opening
of the gate by motor M1).
• If the gate is moving, pressing the central button of the remote con-
trol will cause the gate to stop.
For more information, refer to the user section.
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved.
flashes a er 2 full opening/closing cycles,

10. ADVANCED PARAMETER SETTING

=
=

10.1. Activating automatic closing mode

Attention
By default, the motor will be in sequential mode.
When using your gate in automatic mode, standard EN 12 453
requires the installation of set of photoelectric cells. Switching
to automatic operating mode is not possible if no set of cells is
installed. Somfy recommends the installation of an orange light
and zonal lighting.
N.B.: button 1 and button 2 position
2 buttons
1
1) Place a programmed remote control on the target engraved on the
cover.
2) Press button 1 on the remote control until the
flashes.
=
=
RESET
RADIO
3) Press button 2 on the remote control until the
cator light goes out then comes on continuously.
The indicator light flashes.
=
=
RESET
RADIO
=
=
RESET
RADIO
4 buttons
1
2
2
3 4
=
=
RESET
RADIO
=
=
RESET
RADIO
EN
indicator light
indi-
=
=
RESET
RADIO
10