Switching To Sequential Mode After Activating Automatic Closing Mode; Storing A 3-Button Remote Control; Connecting Additional Devices; General Wiring Diagram - SOMFY AXOVIA 220B RTS Manuel D'installation

EN
4) Press button 1 on the remote control twice.
The indicator light stays on to show that automatic closing mode
is active.
=
=
RESET
RADIO
x2
10.2. Switching to sequential mode a er activat-
ing automatic closing mode
To return to sequential mode, repeat steps 1 and 2 above then briefly
press button 2 on the remote control. The
then flashes. Press button 1 on the remote control twice.

10.3. Storing a 3-button remote control

Attention
It is not possible to store more than 16 transmitters. Delete all the
remote controls and resume programming.
1) Position the remote control on the target engraved on the cover.
2) Briefly press the
the remote control.
The RADIO indicator light comes on then goes out when the button is
released. The remote control has been stored.
=
=
11
=
=
RESET
RADIO
indicator light goes out
Up or Down button
11. CONNECTING ADDITIONAL DEVIC
ES

11.1. General wiring diagram

2 x 0.75 mm²
2 x 0.75 mm²
2 x 0.75 mm²
on
230 V power supply

11.2. Connecting the photoelectric cells

Attention
Photoelectric cells must be connected to use the motorisation in
automatic closing mode.
Axovia 220B RTS
coaxial
cable
2 x 0.75 mm²
4 x 0.75 mm²
2 x 0.75 mm²
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved.