Installation And Setting - Meister MBS600-1 Traduction Du Manuel D'utilisation Original

CAUTION! Before changing the
belt, unplug the power cord!
• W hen working, hold the machine
tightly and guide it with both hands.
• O bserve the general safety notes for
handling electrical tools.
• I f the power cable is damaged, it
must - in order to prevent risks - be
replaced by the manufacturer or their
customer service representative.
Safety marks
The symbols on the housing have the
following meanings:
Do not dispose of with the
household waste!
Important! Observe the
operating instructions!
Voluntary „geprüfte
Sicherheit" seal of quality
(tested safety)
The housing is double
insulated
Always work with a dust
extraction mechanism
connected!
CE mark (conformity with
European safety standards)
Important! Wear ear
protection!
Important! Wear a breathing
mask!
BJ Year of construction
SN: Serial number
40
MW-5455650-Bedien-2009.indd 40 MW-5455650-Bedien-2009.indd 40
SN: XXXXX The first two underlined
numbers give the month of
manufacture.
7 – Installation and setting
Changing the sanding belt
CAUTION! Unplug from the
power source!
Pull the sanding belt tensioning lever
(8) out of the sanding belt guide. This
relaxes the belt and allows it to be
removed from the guide rollers and
replaced with a new one (Figure 2).
CAUTION! Ensure that the
sanding belt is free from bends.
When changing the belt, ensure that
the direction of the arrow on the inside
of the sanding belt matches the arrow
marking (16) on the housing of the unit.
The sanding belt must sit flush with the
right-hand edge of the sanding disc
(11). Return the tensioning lever back
to position. Operate the belt adjuster
(5) to adjust the belt run (Figure 3).
Turning the adjuster screw left or right
with the machine running allows you to
exactly set the belt to run straight and
parallel to the right-hand edge of the
sanding disc (11). If you do not perform
this adjustment, the sanding belt will
be damaged. Sanding belts that show
considerable wear should be replaced.
Dust collection mechanism
• T he electrical tool has mechanisms
that enable you to extract or collect
the sanding dust.
Vacuum adapter (14)
• T o connect external vacuuming
equipment, slide the vacuum
adapter (14) onto the dust exhaust
16.09.20 15:25 16.09.20 15:25