Installation And Setting; Operation; Mode Of Operation - Meister FW250M Traduction Du Manuel D'utilisation Original

MW-5410350-Bediene-1501 13.01.15 11:55 Seite 42
• Wear gloves when handling abrasive
sanding discs and rough materials.
• Wear hearing protection.
• Wear goggles.
7 – Installation and setting
ATTENTION! Always unplug
before changing bits!
ATTENTION! Wear safety gloves
when changing tools! Risk of
injury from sharp-edged tools!
Inserting tools
ATTENTION! Switch off the
appliance, pull out the mains plug!
Insert the scraper tool (4) and the saw
tool (3) (Figure 2) in such a way into the
tool holder (2) that the cams (a) of the
holder fit into two of the gaps (b) of the
tool and ensure that it fits tightly. This
also allows you to set a comfortable
working position.
Fix the tool in place the washer, holding
screw and the adjustment wrench.
The triangular sander adapter (8) is
mounted without the washer. Make sure
you store the washer safely. Fit a
triangular sandpaper sheet with the
appropriate granulation to the hook and
42
eye coating, and press on.
All manuals and user guides at all-guides.com
CAUTION! Ensure that the tool is
mounted in the correct position
(Figures 3, 4, and 5). An incorrectly
mounted tool may lead to injury and
material damage.
8 – Operation
Insert plug into a 230 V~ socket.
ATTENTION! Always start the tool
before bringing it into contact
with material!
Switching on (Fig. 1)
Push the On/Off switch to "I" (ON) and
lock.
Switching off (Fig. 1)
Press the rear part of the On/Off switch
and allow the switch to slide to position
"0" (OFF).
ATTENTION! Do not lay the
machine aside until it has come
to rest!
9 – Mode of operation
• Check that the relevant tool is firmly
seated before and during any work
you carry out.
• Guide the appliance with both hands
as shown in Fig. 6.
• Always work away from the body.
• Start with a shallow working angle
and light pressure.
ATTENTION! To high an
application pressure, too high a
working angle and sharp-edged