Installation And Setting; Operation; Mode Of Operation - Meister MHG2000-2 Manuel D'utilisation Original

• When the hot-air gun is being used in
a standing position, make sure that it
stands on a firm, dustfree surface.
• Vapours can be generated when hot-
air is used. Always make sure the
working area is well ventilated.
The symbols on the housing have the
following meanings:
Important! Observe the oper-
ating instructions!
Housing is double insulated.
CE mark (conformity with
European safety standards)
Do not dispose of with the
household waste!
Voluntary „geprüfte Sicher-
heit" seal of quality (tested
safety)
BJ: Year of construction
SN: Serial number
SN: XXXXX The first two underlined
numbers give the month of
manufacture.
7 – Installation and setting
Mounting the attachment nozzles
A different type of attachment nozzle (7)
may be used according to the work you
are carrying out. The attachment nozzles
are clamped to the accessory mount (5).
In order to ensure a firm seat, the rear
section of the nozzle may need to be
squeezed with a pair of pliers.
34
MW-5460520-Bedien-2008.indd 34 MW-5460520-Bedien-2008.indd 34
CAUTION! Attachment nozzles
that are not securely mounted
may become loose when working and
cause burns!
8 – Operation
Switching on
Set the switch (3) to the I setting. Within
a minute the hot air gun will reach an
operating temperature of 350 °C.
Set the switch to the II setting. Within a
minute the hot air gun will reach an
operating temperature of 550 °C.
Switching off
Switch the unit to the 0 setting and
leave it on the stand (2) to cool down
(Figure 2).
NOTE: If the hot air gun is being
operated with an attachment
nozzle, switch it off after around
3 minutes and allow it to cool down
on the stand for around 3 minutes to
ensure that the unit does not over­
heat!
The integrated stand (2) means that the
unit can be stood up vertically on any
smooth surface (Figure 3). This leaves
both hands free to work.
9 – Mode of operation
CAUTION! Because of the
expected smoke generated when
using the unit, you should always
wear suitable breathing protection!
CAUTION! Never direct the hot
air gun onto the power cable!
The cable should not come into con­
18.08.20 12:37 18.08.20 12:37