Assembly And Adjustment Tasks - Meister MFF1010-1 Mode D'emploi

• Start the machine immediately prior to
contact with the workpiece.
• Never set down the running machine.
• If connection cables are damaged, they
must – in order to reduce the risks – be
replaced by the manufacturer or by
their customer service representative.
Safety symbols
The symbols on the housing have the
following meanings:
Do not dispose of with do-
mestic waste!
Important! Observe operating
instructions!
Wear goggles.
Wear ear defenders.
Wear a dust-protection mask
„Tested Safety" voluntary
quality mark
CE Mark (conformity to
European safety standards)
Housing is double insulated
Always work with a dust col-
lection system connected!
Suitable for biscuit joiners in
sizes Nos. 0/10/20
Nr. 0 / 10
/ 20
MW-5458520-Bedien-1906.indd 37
BJ Year of construction
SN: Serial number
SN: XXXXX The first two underlined
numbers give the month
of manufacture.
7 – Assembly and
adjustment tasks
Milling depth setting (Figures 4 + 5)
Unplug from the power source! The rotat-
ing switch (8) is used to select the stand-
ard settings for the three most frequently
used biscuit dowel sizes by means of the
arrow marking:
0 = Biscuit dowel number 0
(Approximately 47 x 15 x 4 mm)
10 = Biscuit dowel number 10
(Approximately 53 x 19 x 4 mm)
20 = Biscuit dowel number 20
(Approximately 56 x 23 x 4 mm)
The milling depths are preset at the facto-
ry. Corrections may be made, if required,
using the adjustment screw (9). The lock-
nut is used to lock the selected setting.
Height/angle setting
Height setting (Figure 5)
Undo both screws for the angle setting (3)
and height adjustment (5). Set the angle
stop (4) to 90° and set the required milling
height at the work piece. After making the
settings, tighten the screws again firmly.
Heights of 0–35 mm can be set using the
vertical height scale.
37
01.07.19 09:18