Handling The Electrical Plane; Setting The Plane Depth; Switching On; Correct Planing - Meister MEH900-2 Traduction Du Manuel D'utilisation Original

The electrical plane is ready for operation.
6 – Handling the electrical
plane

Setting the plane depth

Figure 6-1: Set the plane depth at the
setting handle.

Switching on

High level of noise development
during operation. Risk of damage to
hearing. Wear ear defenders.
Figure 4-1: Hold the securing button (2)
down and press the On/Off switch (1).
The electrical plane starts. Wait for the
full revolutions.
Bring the electrical plane to the work
piece.

Correct planing

Shavings ejection and dust
development. Risk of damage to
breathing passages. Only plane with
the shavings collection bag mounted.
Figure 6-2: Hold the electrical plane
firmly with both hands. Guide the
electrical plane carefully with even feed
in the direction of feed across the work
piece.
5460150-Elektrohobel-man.indd 55 5460150-Elektrohobel-man.indd 55
Please note:
• The plane shoe must always make
full contact with the work piece.
• The setting handle for the plane depth
may not be adjusted during planing.

Switching off

Lift the electrical plane from the work
piece.
Figure 4­1: Let go of the On/Off
switch (1).
Blade drums that continue
to operate. Risk of injury if touched.
Wait until they have come to a
standstill. As soon as the motor has
come to a standstill, put down the
electrical plane.
Pull the plug out of the power socket.
Empty the shavings collection bag
Shavings collect in the shavings
collection bag. There is a risk of device
damage caused by overheating in the
event that the extraction of shavings is
blocked. Empty the shavings collection
bag in good time.
Remove the shavings collection bag.
In order to empty the shavings collection
bag: Open the zip over a container.
55
04.12.20 11:18 04.12.20 11:18