Calibration Mode; Language - Burkert 8205 Notice D'utilisation

4 OPERATION
4.3 Calibration Mode: Press
The following adjustments are set in the calibration mode display:

LANGUAGE

T ° UNIT
CURRENT
OUTPUT 1
OUTPUT 2
SETPOINT
0......9
CONTROLL
ALARM
HAND
T° SENSOR
FILTER
4.3.1 Language
LANGUAGE ENTER
T ° UNIT
English, German, French, Italian or Spanish.
Temperature unit selection (°C; °F).
Adjustment of the 4...20 mA measuring range (pH or T°).
Selection of output signal 1 (impulse duration or frequency).
Selection of output signal 2 (impulse duration or frequency).
Adjustment of 2 setpoint for pH control (high/low or high/ very
high;...).
Selection of the pH control mode (P; PI; PID).
Adjustment of 2 alarm thresholds for pH or temperature (high/
low or high/ very high;...).
Manual operation selection.
Selection of the temperature entry Pt1000 or Manual (without
Pt1000). Entry of the simulation value.
Damping selection. 10 different steps available.
END
Back to the operation mode and storage of new parameters.
ENTER
PH CONTROLLER 8205
ENTER
simultaneously for 5 seconds
ENGLISH
The selected language is confirmed
by the ENTER key and becomes
DEUTSCH
immediately active.
FRANCAIS
ITALIANO
SPANOL
E-25-