Checking The Rotation Direction; Adjusting The End Limits; Recording The Rts Transmitter - SOMFY Sonesse 30 RTS Notice D'installation

5.2. Checking the rotation direction

1) Press the RTS transmitter UP button:
a) If the shade is raised, the direction of rotation is correct:
move to the section entitled «Adjusting the end limits».
b) If the shade is lowered, the direction of rotation is
incorrect: move to the next step.
2) Press the RTS transmitter My button until the shade
makes an Up and Down movement: the direction of
rotation has been modified.
Press the RTS transmitter UP button to check the
direction of rotation.

5.3. Adjusting the end limits

The limits can be set in any sequence.
1) Press and hold the UP button to move the shade to the
desired up position.
2) Press the My and DOWN buttons simultaneously and
release them, once the shade begins to move. The up
limit is memorized.
3) Press the My button when it reaches the desired down
position.
If necessary, adjust the down position, using the UP or
DOWN buttons.
4) Press the My and UP buttons simultaneously and
release them, when the shade begins to move.
The down limit is memorized.
The shade moves up and will stop at its upper limit.
5) To confirm the end limits press and hold the My button,
until the shade makes an Up and Down movement.
The end limits are recorded.

5.4. Recording the RTS transmitter

Press the programming button on the back of the
RTS transmitter, until the motor makes an Up and
Down movement. The RTS transmitter address is
permanently recorded.
6
1
a
=
b
=
2
1
3
5
PROG.
Copyright © 2013-2016 Somfy SAS. All rights reserved
2
4