SOMFY Sonesse 30 RTS Notice D'installation page 2

These instructions apply to all Sonesse 30 RTS drive, the different versions of which are available in the
current catalogue.
Field of application
Sonesse 30 drive are designed to drive all types of interior blinds and projection screens up to 2Nm
except pantographs.
The installer, who must be a motorisation and home automation professional, must ensure that the motor-
ised product is installed in accordance with the standards in force in the country in which it is installed
such as EN 13120 relating to interior blinds.
Liability
Please read these instructions carefully before installing and using the drive. In addition to following the
instructions given in this guide, the instructions detailed in the attached Safety instructions document
must also be observed.
The drive must be installed by a motorisation and home automation professional, according to instruc-
tions from Somfy and the regulations applicable in the country in which it is commissioned.
It is prohibited to use the drive outside the field of application described above. Such use, and any failure
to comply with the instructions given in this guide and in the attached Safety instructions document,
absolves Somfy of any liability and invalidates the warranty.
Using this drive with any products which are not listed in the attached «Compatibility matrix» document
shall also render invalid any Somfy warranty and release Somfy from any liability.
The installer must inform its customers of the operating and maintenance conditions for the drive and
must provide them with the instructions for use and maintenance, and the attached Safety instructions
document, after installing the drive. Any After-Sales Service operation on the drive must be performed by
a motorisation and home automation professional.
If in doubt when installing the drive, or to obtain additional information, contact a Somfy adviser or go to
the website www.somfy.com.
Specific safety instructions
Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
Attach cables to prevent any contact with moving parts.
If the drive is used outdoors, and if the power supply cable is a type H05-VVF cable, the cable should
be installed in a UV-resistant duct, e.g. under a gland.
Leave the drive power supply cable accessible: it must be possible to replace it easily.
Before installation, check that this product is compatible with the associated equipment and
accessories.
Somfy SAS, F-74300 CLUSES as manufacturer hereby declares that the drive covered by these instructions
when marked for input voltage 230V~50Hz and used as intended according to these instructions, is in compli-
ance with the essential requirements of the applicable European Directives and in particular of the Machinery
Directive 2006/42/EC, and the Radio Directive 2014/53/EU.
The full text
Antoine Crézé, Approval manager, acting on behalf of Activity director, Cluses, 06/2016.
2
TRANSLATED INSTRUCTIONS
of the EU declaration of conformity is available
Copyright © 2013-2016 Somfy SAS. All rights reserved
at www.somfy.com/ce.