Commissioning; Checking The Direction Of Rotation; Setting The End Limits - SOMFY Sonesse 50 RTS Notice D'installation Et D'utilisation Succincte

2.3. COMMISSIONING

2.3.1. Pre-programming the RTS control point
1) Switch on the power supply.
V
2) Press the / buttons on the RTS control point at
the same time: The motorised product moves up and
down (fast raising and lowering), and the RTS control
point is pre-programmed in the motor.

2.3.2. Checking the direction of rotation

1) Press the button on the RTS control point:
a) If the motorised product rises (a), the direction
of rotation is correct: Move onto the section
entitled "Setting the end limits".
b) If the motorised product lowers (b), the direction
of rotation is incorrect: Move onto the next step.
2) Press the my button on the RTS control point
until the motorised product moves up and down: The
3) Press the button on the RTS control point to
check the direction of rotation.

2.3.3. Setting the end limits

The end limits can be set in any order.
1) Raise the motorised product to the desired position by pressing the
V
2) Press the my and buttons at the same time until
the motorised product moves.
The upper end limit is memorised.
3) Press the my button when the motorised product
reaches the desired lowered position. If necessary,
adjust the position of the motorised product using the
V
and buttons.
4) Press the my and buttons at the same time until
the motorised product moves.
The lower end limit is memorised. The motorised
product rises and stops in the raised position.
the motorised product moves up and down.
The end limits are programmed.
Copyright © 2014 Somfy SAS. All rights reserved.
1
1)
2)
1)
3)
my button until
5)
Images not contractually binding
EN
2
a
=
b
=
3)
button.
2)
4)
15