Wiring; Commissioning; Checking The Rotation Direction - SOMFY Roll Up 28 Notice D'utilisation

EN

2. 2. WIRING

⚠
To ensure electrical safety, this Class III motor must
be powered by a «SELV» voltage source (Safety
Extra Low Voltage).
Plug the battery with the motor supply cable.
⚠
Warning: Do not unplug the battery when the motor
works.

2. 3. COMMISSIONING

2. 3. 1. Wake up the drive
For initial unpacking of drive, wake up the drive by briefly
pressing the motor head programming button or plugging
in the charger.
The driven product briefly moves Up and Down 3 times.
1
To avoid accidental programming of drive(s) once awake, follow section "Activate/Deactivate "RTS" radio
technology when control point is temporarily preprogrammed (not paired) to the driven product" to deactivate
RTS.
Β
The drive will go back to sleep if left untouched for 15 minutes.
2. 3. 2. Preprogramming the control point
Press the UP and DOWN buttons simultaneously on the control point:
the driven product moves Up and Down and the control point is temporarily programmed to driven product.

2. 3. 3. Checking the rotation direction

Press the control point UP button:
a) If the driven product raises (a), the rotation direction
is correct: proceed to section "Setting the end limits".
b) If the driven product is lowers (b), the rotation
direction is incorrect: move to the next step.
• b1) Press the control point MY button until the
driven product moves Up and Down: the rotation
direction has been modified.
• b2) Press the control point UP button to confirm the
rotation direction.
4 Copyright © 2017 - 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved
Roll Up 28 WireFree RTS
a
=
b
=
b1 b2
3x