Sun Function; Adjusting The Roller Speed - SOMFY Sonesse 30 RTS Notice D'installation

7.6. Sun function

For this function, you need a Telis Soliris
transmitter.
By default, the Sun function is not active.
1) To activate the Sun function, press
the SELECT button on the Telis Soliris
transmitter, until the shade makes an Up and
Down movement.
2) To deactivate the Sun function, press
the SELECT button on the Telis Soliris
transmitter, until the shade an Up and Down
movement.
When the intensity of the daylight exceeds
the threshold set by the Soliris sensor RTS,
a CLOSURE order is sent to the shade after
2 min.
The shade goes to the My position or to
its down limit, if no My position has been
memorized.
When the intensity of the daylight falls below
the threshold set by the Soliris sensor RTS,
the shade goes to the Sun disappearing
position or stays at its position (My or down
limit), if no Sun disappearing position has
been memorized.
The Wind function is not compatible with this
motor.

7.7. Adjusting the roller speed

1) Press the UP, My and DOWN buttons
simultaneously, until the shade makes an Up
and Down movement once.The shade moves
up and down automatically, in 10 second
cyles.
2) While the shade is moving, briefly press
the UP button, to increase the speed, or
DOWN button, to decrease the speed.
3) To confirm the new speed, press and hold
the My button until the shade makes an Up
and Down movement.
Copyright © 2013-2016 Somfy SAS. All rights reserved
1
2
3
OK
10s
10s
11