Breaking And Chamfering Edges; Planing; Finishing Surfaces; Mounting The Side Stop - Meister MEH900-2 Traduction Du Manuel D'utilisation Original

7 – Breaking and
chamfering edges
Set the plane depth
Driven moving parts. Risk of injury if
switched on unintentionally. Separate
the device from the power supply.
Figure 7-1: Set the plane depth:

Planing

Figure 5-2: Connect the electrical plane
to the power socket.
Figure 6-2: Plane as described under
"Correct planing", page 55.
8 – Finishing surfaces

Mounting the side stop

Driven moving parts. Risk of injury if
switched on unintentionally. Separate
the device from the power supply.
56
Figure 7-2: Mounting the side stop.
5460150-Elektrohobel-man.indd 56 5460150-Elektrohobel-man.indd 56
No accessories are
mounted to break or
chamfer edges.
To finish surfaces,
mount the side stop in
order to make guiding
the plane easier.

Setting the side stop

Figure 7-2: Set the side stop in such a
way that the electrical plane is centred
above the work piece.
Planing
Figure 5-2: Connect the electrical plane
to the power socket.
Figure 6-2: Plane as described under
„Correct planing", page 55.
9 – Planing notches
In order to plane
notches, the side stop
and the depth stop
must be mounted.

Mounting the side stop and

depth stop

Driven moving parts. Risk of injury if
switched on unintentionally. Separate
the device from the power supply.
Figure 7-3: Mount the side stop and the
depth stop.
Setting the side stop and depth stop
Figure 7-4: Mount the side stop and the
depth stop. Formula:
Setting of planing depth
+ setting of depth limiter
= notch depth
04.12.20 11:18 04.12.20 11:18