Erreka TORO Manuel De L'installateur page 68

INSTALLATION
Mount the limit switch magnets
64
Installation Guide
1 Secure the limit switch magnets (4) and (5) to the
magnet carrier plates (6) and (7) using the screws,
nuts and washers (8).
2 Secure the magnet carrier plates (6) and (7) to the
supports (9) using the screws and washers (10).
3 Move the gate manually to the opening position and
adjust the opening magnet (4).

In the gate open position, the magnet (4) must
be opposite the magnetic opening limit switch (Hall
effect sensor) (12).

The distance between the magnets and the
operator frame must be between 15 and 25 mm.
4 Move the gate manually to the closing position and
adjust the closing magnet (5).

In the gate closed position, the magnet (5) must
be opposite the magnetic closing limit switch (Hall
effect sensor) (13).

The distance between the magnets and the
operator frame must be between 15 and 25 mm.
5 Secure the supports (9) to the rack using the
pressure screws (11).
6 Lock the operator using the handle (2).