Total Open/Close Programming - Erreka TORO Manuel De L'installateur

PROGRAMMING AND STARTUP KM1800
4

TOTAL OPEN/CLOSE PROGRAMMING


The programming of the gate open/close is done
using the transmitter, the ST1 mini-pushbutton or
the total key command (A.T.).
Start programming mode
Programme the operation
Finish the programming mode

The total opening and closing of the gate will be
memorised.
1 Place DIP1 and DIP2 in "OFF".

DL3 will remain off.
72
Installation Guide
 Before making the programming, ensure there
is no person, animal or object in the radius of
action of the gate and the mechanism.
1 Close the gate by pressing PUL1.
2 Ensure that DIP7 is "OFF".

Operation times are memorised.
3 Place DIP1 and DIP2 in "ON"; DIP3, DIP4, DIP5 and
DIP6 in "OFF".

DL3 lights
programming mode.
G121T2
1 Start to open the gate: press ST1; the gate begins
to open.
2 Wait for the gate to come to a halt due to the
action of the opening limit switch.
3 Start closing the gate: press ST1; the gate begins
to close.
4 Wait for the gate to come to a halt due to the
action of the closing limit switch.
G95V2
up, indicating that it is in