Pedestrian Open/Close Programming; Selection Of The Modes And Control Board Functions (Sw2) - Erreka TORO Manuel De L'installateur

5

PEDESTRIAN OPEN/CLOSE PROGRAMMING

Start programming mode
Programme the operation
Finish the programming mode

The pedestrian opening and closing of the gate
will be memorised.
1 Place DIP1 and DIP3 in "OFF".

DL3 will remain off.
6

SELECTION OF THE MODES AND CONTROL BOARD FUNCTIONS (SW2)


Using SW2, choose the required options (see "SW2 functions" on page 70).
PROGRAMMING AND STARTUP KM1800
1 Close the gate by pressing PUL1.
2 Ensure that DIP7 is "OFF".

Operation times are memorised.
3 Place DIP1 and DIP3 in "ON"; DIP2, DIP4, DIP5 and
DIP6 in "OFF".

DL3 lights
programming mode.
G121W2
1 Start to open the gate: press ST2; the gate begins
to open.
2 Finish the pedestrian opening: press ST2 at the
required position for the end of pedestrian opening
(DC1).
3 Start closing the gate: press ST2; the gate begins
to close.
4 Wait for the gate to come to a halt due to the
action of the closing limit switch.
G95X2
up, indicating that it
TORO operator for sliding gates
is in
73