Unloading And Replacing Filament Spool - Dremel 3D20 Traduction De La Notice Originale

UNLOADING AND REPLACING
FILAMENT SPOOL
CAUTION: Do not change colour of filament or spool
during building. Doing so will cancel the object and
may damage the extruder.
1. Tap "Setup" on your Dremel 3D20's touch screen
then tap "Filament".
2. Tap "Unload".
3. Your Dremel 3D20 will begin to heat the extruder
and will play an alert tone when it is ready to
unload the filament.
DO NOT PULL THE FILAMENT
WARNING
!
OUT UNTIL INSTRUCTED BY THE
TOUCH SCREEN. DOING SO MAY DAMAGE THE
EXTRUDER.
DO NOT TOUCH THE EXTRUDER
WARNING
!
TIP DURING DREMEL 3D20
OPERATION OR UNTIL IT HAS COOLED DOWN TO AT
LEAST 60°C (140°F). CONTACT WITH THE EXTRUDER
TIP DURING OR AFTER OPERATION BEFORE TIP
HAS COOLED MAY RESULT IN PERSONAL INJURY.
4. Once your hear the alert tone, gently pull the
filament out of the extruder until it is completely
separated from the extruder.
NOTE: A small amount of filament may be
remaining in the extruder. The start of your next
object may have some of this filament colour
until it transitions over to your filament colour.
Allow replacement filament to fully extrude before
beginning next object to ensure consistent colour.
5. If filament cannot be easily pulled out of the
extruder, tap the return arrow. Tap "Setup" then tap
"Preheat". Select maximum temperature and allow
15 minutes to heat. After 15 minutes of heating,
tap the "Arrow" button and repeat steps 1 through
5 above.
NOTE: After the filament is pulled out from the
extruder, filament may be visible at the extruder tip.
The filament debris remaining should be removed
using the unclog tool to prevent clogging. To
remove the remaining filament insert the unclog
tool's point into the extruder intake (top); if any
filament is present, it will exit from the extruder tip.
6. See "Filament Installation" instructions on page
19 to install replacement filament spool.
23