Installing Filament And Getting Ready To Build - Dremel 3D20 Consignes D'utilisation/De Sécurité

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2610035691 03-18 3D20_3D20 3/8/18 10:35 AM Page 25

Installing Filament and Getting Ready to Build

Observe all provided warnings and safety instructions when using the
Dremel 3D20. Failure to do so may result in fire, equipment damage,
WARNING
property damage or personal injury.
1. Ensure the power switch is in the off
position.
2. Remove the Dremel 3D20 lid for better
access to extruder and build platform.
3. If build platform is installed, remove by
pinching the clamp located at the front of
the build platform and lifting the build
platform off the base.
4. Mount filament spool to spool holder and
secure with spool lock.
a. Place filament spool onto spool holder
with spool being fed from the bottom
towards the back of the Dremel 3D20.
LIFT
End of
Filament
b. Insert spool lock into spool holder and
rotate 90 degrees to lock in place.
5. Thread filament through filament guide
tube. The filament can then be inserted
into the extruder intake. This will ensure
the extruder experiences minimal
resistance while building.
Filament
Guide
6. Place Build Tape over Build Platform.
Build
Platform
25
Build Tape

Publicité

Table des Matières
loading

Table des Matières