Installation - Burkert 2036 Manuel D'utilisation

Fig. 16: Assembly
8.3.

installation

Warning!
risk of injury from improper assembly.
Non-compliance with the tightening torques is dangerous due to
possible discharge of medium and possible release of pressure.
▶ Observe the tightening torque (see "Tab. 3: Tightening torque").
22
Actuator
Guide pin
Body screws
Diaphragm
Valve body
english
Type 2036
Assembly
8.3.1. installing the body
Welded body
→
Weld valve body in pipeline system.
Other body designs
→
Connect body to pipeline.
8.3.2. installing the actuator (welded body)
→
Move the actuator to the upper actuator position (CFA, NC: by
applying pilot pressure; CFB, NO: by removing the pilot pressure).
→
Put the actuator / diaphragm on the body with correct alignment
(so that the markings made previously align). In the case of RV110
the four spacer sleeves must be inserted in the designated body
holes (see "Fig. 20: Disassembly / assembly the diaphragm" on
page 28).
→
Tighten the diagonally opposed body screws / nuts until there
is visible, uniform mechanical contact between the valve body,
diaphragm and actuator.
→
Switch the diaphragm valve twice.