After Use / Cleaning And Storage - Cleanmaxx YPF-6517P Mode D'emploi

EN
Steam Blast / Vertical Steam-Ironing
CAUTION!
■ For vertical ironing, the item of clothing must hang on an iron with suffi cient clearance
all the way round so that the heat and moisture does not cause any damage.
In addition to conventional steam-ironing, the iron can also emit a strong blast of steam,
e.g. for smoothing stubborn creases or textiles which are hanging up.
1. Make sure that the water reservoir (13) is fi lled (see the "Filling the Water Reservoir"
section).
2. Heat up the device (see the "Ironing" section).
3. Move the steam switch (5) to position
The lower the ironing temperature, the weaker the production of steam and the
longer it takes for more steam to be produced.
Spray Function
The spray function is suitable, for example, for moistening delicate textiles which cannot
be steam-ironed. This function is independent of the steam function and is possible at
any temperature.
The water reservoir must have been fi lled (see the "Filling the Water Reservoir" section).
• Press the
nozzle (2) onto the fabric.

After Use / Cleaning and Storage

CAUTION!
■ Do not use any corrosive or abrasive cleaning agents to clean the device. These can
damage the surface. Do not use any metal objects to remove dirt from the bottom of
the iron.
1. After ironing, move the steam switch (5) to position
temperature control (12) to the MIN position.
2. Place the device upright on its base (9).
3. Remove the mains plug from the plug socket.
4. Allow the bottom of the iron (1) to cool down completely.
When performing vertical steam-ironing on delicate
fabrics, hold the iron a few centimetres away from the
fabric.
4. Press the steam burst button (6), move the bottom of the
iron (1) a little in front of or on the fabric and then release
the button again.
5. Wait a few seconds before the steam burst button (6) is
pressed again.
spray button (4) a few times. Water will be sprayed through the spray
22
(Steam on).
(Steam off) and move the