Spray Function; Vertical Steam-Ironing; After Use; Cleaning And Care - Cleanmaxx TK-7271 Mode D'emploi

Spray Function

• To moisten your textiles, press the
through the water nozzle onto the textiles.
Note: This function is independent of the steam function and is possible at any tem-
perature.

Vertical Steam-Ironing

CAUTION!
❐ Make sure when doing vertical ironing that there is plenty of space around the item
of clothing which is to be ironed. You may only perform vertical ironing if the item of
clothing is hanging on a hanger and cannot come into contact with other garments,
objects, people or animals.
❐ Note the tips provided in the "Ironing Recommendations" and "Use" chapters!
• Vertical steam-ironing is suitable for hanging textiles (jackets, suits, curtains) and for
removing creases.
• Hang up the laundry which is to be ironed only in places where heat and moisture
cannot do any damage, e.g. NOT in front of wallpaper, windows or mirrors.
• The steam function switches off automatically as soon as the device is in a vertical
position. During vertical ironing, you should therefore press the
ton (12) and move the bottom of the iron (6) up and down on the fabric.

After Use

1. After use, move the steam quantity control to
min and pull the plug out of the plug socket.
2. Place the device upright on its base and allow it to cool down completely.
3. Empty the water reservoir each time after you use the device. To do this, open the
water reservoir cover, hold the device over a sink or similar outlet and turn the device
upside down. The remaining water will now run out of the reservoir.
4. Clean the device in the manner described in the "Cleaning and Care" chapter.

Cleaning and Care

CAUTION!
❐ Remove the plug from the mains socket before cleaning the device.
❐ After use, the device may still be very hot. Allow the device to cool down completely
before you empty the water reservoir and/or clean the device and store it away.
❐ Never immerse the device in water or other liquids!
❐ Never touch the device, the cable or the plug with wet hands.
❐ Do not use corrosive or abrasive cleaning agents or cleaning pads for cleaning.
These can damage the surface.
08951_DE-GB-FR-NL_V1.indb 24 08951_DE-GB-FR-NL_V1.indb 24
spray button (13). This will then spray water
, move the temperature control to
24
steam burst but-
07.08.2014 14:38:17 07.08.2014 14:38:17