Cleaning And Storage - Cleanmaxx YF-418-12 Mode D'emploi

Masquer les pouces Voir aussi pour YF-418-12:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
If the control lamp (1) lights up during use, the device is reheating. Do not press
the steam release button (2) during the heating process in order not to slow this
down and to prevent a danger of scalding from hot water which may escape. Wait
until the control lamp (1) goes out again.
7. If steam stops being produced, the water reservoir is empty. Allow the device to cool
down for a few minutes and then top up the water reservoir again (see the "Filling the
Water Reservoir" chapter). Never use the device without water to prevent damage
to the device!
Tips on Use
Delicate items of clothing should be steamed inside out.
Trousers are easier to smooth if they are hung up by the trouser legs.
Do not hold down the steam release button (2) continuously during use. This reduces
the steam pressure.

Cleaning and Storage

CAUTION!
Allow the device to cool down completely before the water reservoir is emptied and /
or the device is cleaned and stored away.
Never immerse the device in water or other liquids!
Never touch the device, the mains cable or the mains plug with wet hands.
Do not use any corrosive or abrasive cleaning agents or cleaning pads to clean the
device. These can damage the surface.
1. Make sure that the device is switched off and the mains plug has been removed from
the plug socket.
2. Place the device on a water-resistant and heat-resistant surface.
3. Allow the device to cool down completely.
01535_DE-EN-FR-NL_A5_V3.indb 18
01535_DE-EN-FR-NL_A5_V3.indb 18
18
5. Move the brush attachment (6) in strokes over the fabric and
press the steam release button (2) at regular intervals as you
do so. However, do not keep the steam release button (2)
held down constantly! It is important for the brush attach-
ment (6) to touch the fabric so that it is freshened up.
6. Open the clip of the crease attachment (7) by pressing the
lever slightly towards the device. Clamp the fabric of the item
of clothing to be smoothed in the crease attachment (7) and let
go of the lever again. Slowly pull down the item of clothing and
press the steam release button (2) at regular intervals as you
do so. However, do not keep the steam release button (2)
held down constantly!
21.08.2018 14:10:44
21.08.2018 14:10:44

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

01535

Table des Matières