Storage; Self-Cleaning Function - Cleanmaxx SG-5510-6 Mode D'emploi

EN
5. Empty the water reservoir. To do this, open the water reservoir cap, hold the iron
over a sink or similar outlet and turn it upside down. Allow all of the water to fl ow out
of the reservoir.
6. Then connect the iron to the mains power and move the steam quantity control and
temperature control to the maximum setting for one to two minutes so that the rest
of the water evaporates. Then repeat steps 3 and 4.
7. If necessary, wipe down the outside of the device with a soft, slightly damp cloth and
dry it with a soft cloth.

Storage

1. Once the device has completely cooled down and the water reservoir is empty (see
the "Use" chapter, "After Use" section), place it on the adapter.
2. Wind up the mains cable.
3. Store the device in a dry, clean, frost-free location which is out of the reach of chil-
dren and animals.

Self-Cleaning Function

CAUTION!
■ Danger of scalding! Hot water and steam will emerge from the bottom of the iron dur-
ing the self-cleaning process. Keep the bottom of the iron away from all body parts
and delicate materials when you press the self-cleaning button (16)!
■ Only ever press the self-cleaning button to perform self-cleaning and not during
ironing!
As the temperature drops quickly with this function, we recommend that the iron
should be attached to the mains cable and connected to the mains power.
The device has a self-cleaning function allowing limescale residues to be removed from
the device. Additional descaling of the device is not necessary. Perform the working
steps which are described below regularly (at least every 10 operating hours):
1. Fill the water reservoir up to the max marking with tap water (see the "Use" chapter,
"Filling the Water Reservoir" section).
2. Place the device on an ironing board or on an even, stable, heat-resistant and mois-
ture-resistant surface.
3. Attach the iron to the adapter and insert the mains plug into a properly installed plug
socket that is easily accessible.
4. Heat the device up to the highest temperature setting.
5. Hold the device horizontally over a sink or similar outlet.
26
6. Press the self-cleaning button (16).
7. Allow the water reservoir to run completely empty. Tilt the
device back and forth slightly to allow the water to run out
of all nozzles.
8. Repeat the cleaning process several times until no more
limescale residues emerge from the nozzles.