Güde GTKS 315/230V Mode D'emploi page 30

Pic. 17
Pic. 18
Pic. 19
Pic. 20
• Mount part 23 to part 24 using two wing bolts and
two fly nuts (see pic. 17).
• Insert the assembled part in the guide rail and
mount it using two M6x30 half-round bolts with a
square body, two M6 washers and two M6 female
screws to positions A and B. Screw the bolts in
turn until part 24 is tightened. Then loosen the
nuts so that part 24 could move freely in the guide
rail (see pic. 18).
• Mount part 22 using two M6x30 half-round bolts
with a square body and two M6 washers (see pic.
19). Then apply the same procedure as specified
above. Part 24 will move freely in the guide rail.
• The wrench and the shifting rod are hung to the
pre-installed hook.
30