Güde GTKS 315/230V Mode D'emploi page 28

Pic. 8
Pic. 9
Pic. 10
Pic. 12
• Take four M4x12 hex head bolts and four M4
washers and mount part 14 to part 13 (see pic. 8).
• Take four M4x12 hex head bolts, four M6 washers
and four M6 nuts and mount part 16 (axle) + part
17 (pulley 2x) to part 4 and part 5 (see pic. 9). The
bolts must not be tightened too much.
• Tighten the bolts in positions A and B closely.
Tighten the bolts in positions C and D so that the
bolt ends are in the same level as the nuts (see
pic. 10).
• Except for bolts in positions H and I, tighten all the
bolts, starting with A and ending with G (see pic.
12).
28