Publicité
Les langues disponibles
Les langues disponibles
Circular saw blade rotation direction
Make sure the circular saw blade rotation direction corresponds to the direction shown on the protection cover (23).
Plugging
Compare the voltage specified on the appliance type label (at the side of the bench desk), e.g. 230 V, with the line
voltage and connect the saw to the appropriate outlet grounded in accordance with applicable regulations.
AC engine:
-
Use an earthing contact outlet, line voltage of 230 V or 400 V with a safety switch against stray current and a
16 A fuse.
Three-phase engine:
-
Use a CEE, + N + P three-pole outlet, line voltage of 380 V or 400V with a safety switch against stray current
and a 16 A fuse.
Use a drop or extension cable according to DIN 57 282(H 07 RN-F) of minimum cable cross-section of
2
1.5 mm
for a cable length within 25 m
-
2
2.5 mm
for a cable length of more than 25 m
-
Switching the appliance on
= by pressing the upper green button on the switch.
The appliance is switched off automatically in case of power outage. Press the green button to switch the appliance
on again.
Switching the appliance off
= by pressing the bottom red button
The appliance is fitted with a stop engine. The circular saw blade must stop within 10 seconds after the appliance is
switched off. If such time is exceeded, the stop engine brake is defective. Have it repaired by the manufacturer or
any company authorised by the manufacturer.
Caution: Saw with a defective brake cannot be used.
23
Publicité
