Güde GTKS 315/230V Mode D'emploi page 21

Using the appliance as designated
The circular bench saw cannot be used on sites.
-
Use the circular saw blade only for straight and transverse cutting of massive wood and board
-
materials such as chipboard, blockboard and fibreboard of a square or rectangle cross-section and
use only the CV circular saw blades or hard metal (HM) circular saw blades. Using high-speed steel
(HSS) circular saw blades is not allowed. The circular saw blade diameter must be 300 to 315 mm.
Cross cuts may only be performed using the installed parallel stop.
-
To use the appliance as designated, the manufacturer's conditions regarding the operation,
-
servicing and repairs must be met and the safety instructions included in the Operating Instructions
must be followed.
Any other use of the saw exceeding the specified extent will be considered a use in conflict with the
-
designation. The manufacturer will not be liable for any damage of any kind caused by using the
appliance in that manner; the risk will be bore by the user.
The circular bench saw may only be used, repaired and maintained by persons over 18 years of
-
age. Any metal parts (nails, etc.) must be removed from the cut wood.
Residual risks
Even when the saw is used as designated with all safety provisions being followed, there may be some residual
risks induced by the design, subject to the specific purpose of use:
Risk of injury of fingers and hands by the cutting tool (circular saw blade) or cut material if the saw is handled
-
unprofessionally.
Injury by a thrown-away piece of the cut material.
-
Circular saw blade cracking and throw-away.
-
Threat by current when using an optional supply cable.
-
Contact with conductive parts of the appliance in case of exposed electrical installation.
-
Hearing damage as a result of long working without protective headphones being used.
-
Emission of unhealthy wood sawdust when using the appliance without exhaustion.
-
Residual risks can be minimised if all safety instructions and instructions given in the "Using the appliance as
-
designated" Article and the Operating Instructions are followed as a whole.
21