Güde GTKS 315/230V Mode D'emploi page 20

2. Wear close-fitting working clothing. Take off any jewels and wristwatch.
3. Wear protective head phones (the acoustic pressure level in the place of work usually
exceeds 85 dB(A)).
4. Do not operate the circular bench saw in a moist or wet environment or near flammable
liquids and gases.
5. Persons under 18 years of age are prohibited to operate the circular saw.
6. Operate the circular saw only when the protective equipment is installed completely and
properly.
The board splitter included in the supply must be used. The method of adjusting the board
splitter can be seen in pic. 17 of the Operating Instructions.
7. Do not use any circular saw blades that are cracked or deformed. The circular saw blade
should always be properly sharpened.
8. Do not use high-speed steel (HSS) circular saw blades; tools in accordance with prEN 847-1
to be used only.
9. The operator is liable towards third parties in the place of work.
10. Keep children in a safe distance from the appliance. Never leave the saw unattended.
11. Using grooving equipment and slot milling tools is not allowed.
12. When cutting logs, use equipment securing the cut material against turning around on both
sides of the circular saw blade.
13. It is necessary to prevent cuttings from getting caught by the circular saw blade ring gear
and being thrown away. Do not remove any chippings, sawdust and waste from the
dangerous area around the circular saw blade with hands.
14. Use the shifting rod – see pic. 22 for straight cutting of narrow pieces (distance between the
circular saw blade and the parallel stop smaller than 120 mm).
15. If the sawed joint is driven out, replace the bench insert.
16. The appliance must be switched off and unplugged for the following works
- repairs
- servicing and cleaning
- troubleshooting
- saw transport
- circular saw blade replacement
- when leaving the saw (even for short work interruptions)
17. To ensure perfect and safe operation in enclosed places, the appliance must be connected
to the sawdust exhaustion equipment (e.g. small portable vacuum cleaner). Air speed in the
exhaust nozzle of at least 20 m per second
Vacuum: 1.6 kN per m
18. Never use a connection line that is defective. Electrical connection or repairs of electrical
components of the appliance must be provided by a professional electrician. In doing so,
local regulations, in particular, protective measures must be followed.
2
(1,600 Pa)
20