Güde GTKS 315/230V Mode D'emploi page 24

Engine circuit switch
The engine is fitted with a safety switch and is automatically switched off when overloaded. After being cooled
down, the engine may be switched on again.
Height adjustment
= adjusting the required cut depth using the crank (2).
Angular adjustment
= loosen both bolts using the star-handle (3),adjust the required angularity, lock in this position by tightening both
bolts using the star-handle.
Hidden cuts
= use the standard board splitter.
Using other circular saw blades
= Make sure the board splitter thickness is "s", which is etched on the side of the board splitter
The board splitter must not be thinner than the circular saw blade body and must not be thicker than the sawed joint
width. The minimum and maximum circular saw blade diameter and the hole diameter is given on the appliance
type label.
Using the extension desk
= If there is any other person working with you, he/she must stand on the wood taking end of the bench
extension.
Servicing and maintenance
Unplug the appliance
Check whether the appliance is not damaged every time it is to be used. If the appliance is not in a perfect condition,
do not switch it on and have it repaired by an expert.
To maintain functionality of the circular saw bench saw, please follow these instructions:
Clean and lubricate the moving parts at regular intervals
-
In case of heavy soiling, clean the engine cooling fins to provide adequate cooling
-
Keep the circular saw blade with no signs of rust and resin
-
See the Accessory equipment for removing resin remains off the saw bench desk!
-
The circular saw blade (part subject to wear) gets blunt after long or more frequent using = sharpen or replace
-
it
24