Using The Accessories For Centring The Wheels - Corghi ProLine Truck 150 Manuel D'utilisation

USING THE ACCESSORIES FOR CENTRING
¢ Truck centring equipment (optional)
o Support flange. It has holes for fixing to the flange of the machine
o Cone Ø276-286
o Cone Ø210-217.5 / Ø217.5-225
o Manual locking ring nut
Wheel centring procedure using the accessories described above must be carried out
as follows:
fit the support flange on the machine and fix it to the flange of the machine, using the
two supplied screws, lift the wheel by means of a lift and bring it into contact with the
support flange. Insert the suitable cone for the wheel to be locked and tighten the ring
nut appropriately.
¢ Professional truck centring kit (optional)
o Rear pre-centring flange Ø280mm.
o 2 Contrast flanges. It has holes for mounting the tapered pins.
o Standard series of five tapered tips for centring the rims with fastening holes from Ø
16 to Ø 33 mm. The table below shows the diameters reached with the two flanges
with 4 and 5 tips.
User manual ProLine Truck 150
THE WHEELS
11
UK
89