Using The Product; Launching The Program; Key To Commands And Meaning Of Icons; User Interface And Windows - Corghi Cal One-Touch Manuel D'utilisation

Internet site for upgrading the Cal One Touch.
When the activation is complete, the Cal One
Touch can be used normally.
IMPORTANT
If the activation procedure is interrupted, it
will not be possible to use the self-diagnosis
software.
IMPORTANT
Once the activation procedure is complete
(or after an upgrade), the software can only
work with the self-diagnosis module used for
the activation, as the program recognises that
serial number.

USiNG ThE PrODUCT

Warning: the device only works if the vehicle
panel is switched on.

Launching the program

The Cal One-Touch is automatically launched by
the aligner software if the vehicle selected has
electronic steering or ESP.
Key to commands and meaning
of icons
The table below lists the icons that appear in the
program. For each icon, there is a brief descrip-
tion of its function.
NOTE
When using the program on a PC, it is possible
to see the command associated with each icon
by positioning the cursor on the icon itself. The
"tool-tip" will appear, with a detailed description
of the command.
Right-hand arrow key
This allows you to continue with the proce-
dure.
Left-hand arrow key
This allows you to go back to the previous step.
This key is only present if necessary.
Key to exit the self-diagnosis software
This allows you to exit the procedure.
Negative confirmation key
This is used to abort a procedure or make a nega-
tive confirmation for a software request.
It is identified as the "ESC" key.
18
Positive confirmation key
This is used to continue a procedure or make a
positive confirmation for a software request. It is
identified as the "ENTER" key.
Indication of communication with
the vehicle electronics
If the animation shows a red "X",
the communication with the vehi-
cle electronics has not been established. To try
again, press the key with the right-hand arrow.
Errors animation
If this animation is displayed on
the main screen, there are errors in
the vehicle electronics. This means
the zero-setting of the steering angle may not
be possible, depending on the type of vehicle
electronics. In any case, if the zero-setting is
necessary the software will try to perform it,
showing the result in the final report.

User interface and windows

The table below gives some examples of the
windows that will appear when using the program.
Depending on the type of car already selected,
it may be necessary to make a further selection
in order to determine what type of electronics
are present on the car.
Selecting the vehicle
(these steps may not be necessary)
Operator's manual Cal One-Touch
5