Entering Wheel Size - Corghi ProLine Truck 150 Manuel D'utilisation

Now the operator can set the data of the
wheel to be balanced or select one of the
programs available.
12
ENTERING WHEEL
SIZE
The dimensions of the wheel to balance can
be entered in two ways:
• Manual Mode.
• Semi-automatic Mode.
Note: All machines are equipped with a
graduated scale for manually measuring
distance.
Manual entry of wheel
dimensions for the DYN and
Program Types (ALU 1-2-3-4-5)
To manually enter a wheel size, proceed
as follows:
1. Fit the wheel on the shaft and tighten it
with the ring nut.
92
B
A
2. Extract the distance sensor and place it
on the wheel as shown in Figure 13.
3. Read the distance value on the graduated
scale as shown in Figure 13. The distance
value is always expressed in millimetres.
4. Press [P1] key
and then press the [P4]
key within 1.5 seconds
the read value. If you do not press the
[P4] or [P5] key within this time limit,
the machine will return to the previous
display. In this case, you can press the
[P1] key again
the data.
5. Measure the width of the wheel with
the special gauge supplied or read the
value of the width indicated on the rim.
The value of the width can be in inches
or millimetres according to the selected
unit of measurement.
6. Press [P2] key
and then press the [P4]
key within 1.5 seconds
the read value. If neither of these two
buttons is pressed in this time limit,
the machine will return to the previous
display. In this case, you can press the
[P2] key again
the data.
7. Read the value of the diameter indicated
on the rim or tyre. The value of the diameter
User manual ProLine Truck 150
to change distance
or [P5]
to enter
to enter or edit
to change width
or [P5]
to enter
to enter or edit