Corghi ProLine Truck 150 Manuel D'utilisation page 115

calibration in progress.
Spins stopped using the [P10] Stop key
can be repeated by pressing the
[P8] Start key
How to exit the TRUCK Wheel Type
calibration of the machine
At any time it is always possible to exit
the calibration procedure in progress
by pressing [F+P3]
. The machine will return to SERVICE
mode displaying SEr SEr. To return to
NORMAL mode, press [F+P3]
+ again. The calibration
procedure in progress will be cancelled
and the machine will use the previous
calibration values.
User manual ProLine Truck 150
.
+
Machine calibration for
CAR/SUV (car/off-road)
wheel types
Calibration for the CAR and SUV Wheel
Types is the same.
To perform machine calibration, you must
first provide for the following material:
• A balanced wheel with a steel rim
having the following
Diameter 15" Width 6". Wheels with
dimensions similar to those specified
can also be used provided that the
difference is small. It is not possible to
use wheels with aluminium rims.
• One 50-gram weight (preferably made
of Iron or Zinc).
To perform the machine calibration,
proceed as follows:
1. Switch on the machine;
2. Remove the wheel and any other
accessories from the shaft;
3. Press the [F+P3]
. SEr SEr will be displayed.
This means that SERVICE mode has
been entered (service programs);
4. Press the [P3] key
words CAL TRC will appear on the
screen (machine calibration for truck
wheels);
5. Use [P4]
to select the type of CAR calibration
(car and light off-road wheels).
6. Press the [P3] key
words CAL 0 will be displayed;
dimensions:
key +
. The
or [P5]
. The
115
UK