Corghi ProLine Truck 150 Manuel D'utilisation page 93

can be in inches or millimetres according
to the selected unit of measurement.
8. Press the [P3] key
diameter value and then press the [P4]
o [P5]
1.5 seconds to enter the read value. If
neither of these two buttons is pressed
in this time limit, the machine will return
to the previous display. In this case, you
can press the [P3] key again
enter or edit the data.
Fig.13: Manual acquisition of wheel
dimensions: placing the Distance sensor
Manual entering of the wheel
dimensions for ALU 1P, ALU 2P
program types
To manually enter a wheel size, proceed
as follows:
1. Fit the wheel on the shaft.
2. If the selected program type is ALU 1P,
remove the distance sensor and place
it on the wheel as shown in Figure 15.
3. If the selected program type is ALU 2P,
extract the distance sensor and place
it on the wheel as shown in Figure 14,
otherwise proceed with step 4.
4. Read the internal plane distance value
on the graduated scale. The distance
User manual ProLine Truck 150
value is always expressed in millimetres.
5. Press the [P1] key once
to change the view the parameter A-1 (internal plane
distance) and, within 1.5 seconds, press
key within the [P4]
to enter the read value. If neither of these
two buttons is pressed in this time limit,
the machine will return to the previous
display. In this case, you can press the
to [P1] key again
the data.
6. Move the distance sensor and place it
on the plane selected for the external
weight as shown in Figure 16.
7. Read the distance value on the
graduated scale. The distance value is
always expressed in millimetres.
8. Press the [P1] key
13
quick succession until A-2 (external
plane distance) is viewed and, within
about 1.5 seconds, press [P4]
or [P5]
If neither of these two buttons is pressed
in this time limit, the machine will return
to the previous display. In this case, you
can press [P1]
sequence to enter or edit the data.
to
or [P5] key
to enter or edit
twice in
to enter the read value.
twice in rapid
93
UK