Feedback Window; Shutting Down; Using The Automatic Wheel Clamping System C - Corghi EM9980 Manuel D'utilisation

- Fill out the empty fields in the report by
pressing the text Entry button
- Start the print process with the Print button
.

FEEDBACK WINDOW

The feedback window, as shown in the figure
below, displays the following information:
- Name of operator (see the "Customisation"
section).
- Wheel dimensions during the last spin: white
if measured automatically; or yellow if set
manually.
or grey if calculated statistically and NOT ac-
quired automatically by the machine.
CAUTION
This data (in grey) may NOT correspond with
the wheel's rated dimensions. This display
does NOT indicate a machine error (as the
dimensions are calculated statistically and
NOT automatically measured) or an error in
the unbalance display.
- The status of the clamping brake (enabled or
not enabled)
- Enabling of the WM programme
- The selected balancing environment (ref. "Con-
figuration Programmes" section)

SHUTTING DOWN

54
This function starts the shutdown process which
protects the Windows operating system installed
on the mother board and depowers the machine.
.
Proceed as follows:
Press the Enter button
-
- Wait for the PC to be turned off completely
as confirmed by an intermittent beep.
- Press the switch on the back of the body (C,
Fig. 5).
USING THE AUTOMATIC
WHEEL CLAMPING
NOTE:
After every power on, the first time the automatic
wheel clamping system is activated using the
pedal, the machine will perform a calibration by
automatically moving the two ratchets located on
the hub towards the outer side. When calibration
is complete, the operator can use the machine
as described below.
Wheel locking procedure with the automatic C:
Centring with cone at front
- Fit the wheel on the shaft, sliding it into place
until it rests against the flange.
- Fit the most suitable cone on the shaft and
insert it into the central hole of the wheel.
- Fit the locking device by making it slide on
the hub until it comes into contact with the
cone.
- Press the control pedal for at least one second.
Centring with cone at rear
- Fit the most suitable cone for the central hole
of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into
place until the cone comes into contact with
the plate that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on
the hub until it comes into contact with the
wheel.
- Press the control pedal for at least one second.
Wheel release
- Press the control pedal for at least one second
to release the wheel from the flange.
EM9980 - Operator's manual
.
SYSTEM C