Corghi ProLine Truck 150 Manuel D'utilisation page 114

Machine calibration for
truck wheel type
To perform machine calibration, you must
first provide for the following material:
• A balanced wheel with a steel rim having
the following dimensions: Diameter
22.5". Wheels with dimensions similar
to those specified can also be used
provided that the difference is small.
It is not possible to use wheels with
aluminium rims.
• One 300-gram weight (preferably made
of Iron or Zinc).
To perform the machine calibration,
proceed as follows:
1. Switch on the machine;
2. Remove the wheel and any other
accessories from the shaft;
3. Press the [F+P3] key
. SEr SEr will be displayed.
This means that SERVICE mode has
been entered (service programs);
4. Press the [P3] key
words CAL TRC will appear on the
screen (machine calibration for truck
wheels);
5. Press the [P3] key
words CAL 0 will be displayed;
6. Press the [P8] Start key
machine will carry out a spin. At the
end the words CAL 1 will appear on
the screen.
7. Mount the wheel on the shaft and enter
the wheel dimensions by pressing the
114
[P1]
keys
not possible to enter the data with the
automatic acquisition system;
8. Press Start key [P8]
machine will run a second spin;
9. At the end of the spin, manually rotate
the wheel until the left display shows
the value 300. On the inner side of the
wheel, at 12 o'clock, apply the 300 g
weight.
+
10. Press Start key [P8]
machine will run a third spin;
11. At the end of the spin, manually rotate
the wheel until the right display shows
the value 300. Remove the weight of
300 grams from the internal side and
apply it on the external side of the
wheel at 12 o'clock.
. The
12. Press Start key [P8]
machine will run a fourth spin;
. The 13. Calibration is finished: the machine
automatically exits the calibration
program and returns to NORMAL
mode, ready to be used.
. The
If you have anomalies during the
calibration procedure, the machine will
display the error message (for example
ERR 025). See section "Error codes"
and act accordingly to eliminate the
problem and continue/repeat/cancel the
User manual ProLine Truck 150
, [P2]
and [P4]
to edit the value. It is
, [P3]
or [P5]
: the
: the
: the