Corghi ProLine Truck 150 Manuel D'utilisation page 126

Error Brief
code description
026 NO –A-
027 NO –B-
028 INN IMB
030 CAR CAL
031 TRC CAL
032 DIA CAL
036 NO IMB
037 NO IMB
039 W.GUARD
044 DIA OFF
126
Error display
(1)
Spin without weight or no
OPERATOR internal pick-up A signal
CONFIRMATION in the Cal2 calibration
Spin without weight or no
OPERATOR external pick-up B signal
CONFIRMATION in the Cal2 calibration
Spin with weight on the
internal side during the
OPERATOR Cal3 calibration phase.
CONFIRMATION In this phase, the weight
must be on the external
No calibration data for
OPERATOR the CAR/SUV (passenger
CONFIRMATION car and off-road vehicle)
OPERATOR No calibration data for the
CONFIRMATION TRUCK Wheel Type.
OPERATOR WARNING: the diameter
CONFIRMATION sensor is not calibrated.
CAUTION: Absence of
wheel imbalance in
ALU/ALUP and Dynamic
balancing programs.
It is not possible to
run the low speed RPA
CAUTION: Absence of
wheel imbalance in Static
balancing programs.
It is not possible to
run the low speed RPA
WARNING/ERROR The
wheel guard is lifted: the
requested action cannot
WARNING: Diameter
OPERATOR
missing. It is not possible
CONFIRMATION
to perform the action
Description
phase.
phase.
side.
Wheel Type.
procedure.
procedure.
be performed.
sensor disabled or
required.
User manual ProLine Truck 150
Notes
Apply the intended weight
and repeat the spin. If the
error persists, contact technical
support.
Apply the intended weight
and repeat the spin. If the
error persists, contact technical
support.
Remove the weight from the
internal side and apply it on
the external side; then repeat
the spin. If the error persists,
contact technical support.
Carry out the calibration of
the machine for the CAR/SUV
Wheel Type.
Carry out machine calibration
for the TRUCK Wheel Type.
Contact technical support.
Check that the RPA program is
enabled as described in the
chapter "Automatic Position
Search (RPA)".
Contact technical support.