Corghi ProLine Truck 150 Manuel D'utilisation page 127

Error Brief
code description
046 NO DIA
048 CAL FAR
050 NO HYD
051 TOO FAR
052 NOT INC
054 CAB DSC
056 HIG TMP
057 OVR VOL
058 UND VOL
059 SOV RA
062 bAd tAS
(1) The error code can be exited in the following ways:
OPERATOR CONFIRMATION
The machine exits the error code display when the operator presses any key (except for
[P7] ).
User manual ProLine Truck 150
Error display
(1)
CAUTION: The Diameter
OPERATOR
sensor is enabled but
CONFIRMATION
CAUTION: The Diameter
OPERATOR
sensor is too far from the
CONFIRMATION
calibration point.
CAUTION: Absence of
wheel external imbalance.
OPERATOR
It is not possible to
CONFIRMATION
use the Hidden Weight
CAUTION: Hidden
Weights program: the
OPERATOR
selected point is too
CONFIRMATION
far from the external
imbalance position.
CAUTION: Hidden
Weights program: the
OPERATOR W external imbalance
CONFIRMATION position is not between
the selected W1 and W2
Inverter cable not
High temperature on
Over voltage on inverter.
Undervoltage on inverter.
Inverter overload.
An incorrect password
has been entered OR the
OPERATOR maximum time to enter
ACTION the password (5 seconds)
has elapsed without
entering the password.
Description
NOTE: if [F+P2] is pressed the
machine automatic acquisition
system is temporarily disabled
disconnected. and the operator can enter the
program.
up to 120° from the imbalance
Choose W1 and W2 points so
that they include the external
points.
connected.
inverter.
remove the error and again F +
Notes
diameter manually.
Contact technical support.
The point must be included
position of the W external
plane.
imbalance position of W
external plane.
Contact technical support.
Contact technical support.
Contact technical support.
Contact technical support.
Contact technical support.
Press the F + P3 keys to
P3 to exit the service area.
UK
127