Corghi ProLine Truck 150 Manuel D'utilisation page 125

Error Brief
code description
(Keycode of
015 the locked
button)
016 DIS OUT
018 NO BTI
019 NO CP
020 NO EEP
021 EEP ERR
022 -A- OUT
023 -B- OUT
024
025 SHF IMB
User manual ProLine Truck 150
Error display
(1)
PERMANENT
Keypad blocked at
UNTIL TURNED
OFF
CAUTION: Internal sensor
is not in rest position at
OPERATOR
start-up of the machine
ACTION
or when [P8] Start is
communicate with
expansion board.
CAUTION: Communication
Lack of communication
with the eeprom memory.
No machine calibration
OPERATOR
data or incorrect
CONFIRMATION
calibration data.
OPERATOR ERROR: internal pick-up A
CONFIRMATION
OPERATOR ERROR: external pick-up
CONFIRMATION
OPERATOR ERROR: Internal timer
CONFIRMATION channel too high
Presence of weight during
OPERATOR
the Cal0 calibration
CONFIRMATION
Description
start-up.
disappear. If the error persists,
pressed.
Switch off the machine, wait a
Impossible to
again. If the error reoccurs, try
the procedure again two/three
Turn the machine off and then
process failure.
anomaly. Turn the machine off
and then on again. If the error
too high.
anomaly. Turn the machine off
and then on again. If the error
B too high.
anomaly. Turn the machine off
and then on again. If the error
Remove the weight and repeat
phase.
Notes
Release all keys, then restart
the machine. If the error
persists, contact technical
support.
Set the sensor to its rest
position: the error should
contact technical support.
few seconds and switch it on
times. If the error persists,
contact technical support.
on again. If the error persists,
contact technical support.
Contact technical support.
Carry out calibration for the
CAR/SUV Wheel Type and/or
for the TRUCK Wheel Type.
If the error persists, contact
technical support.
Excessive imbalance or
persists, contact technical
support.
Excessive imbalance or
persists, contact technical
support.
Excessive imbalance or
persists, contact technical
support.
the spin of the Cal0 phase.
If the error persists, contact
technical support.
UK
125