If you want to change the standard setting:
• Press the > button (3). The amount input starts to blink.
• Turn the Control button (2) until the desired amount blinks.
• Press the > button (3). The foam percentage input starts to blink.
• Turn the Control button (2) until the desired number blinks.
• The settings are saved by pressing the Exit button (4).
• Press the Control button once.
• The cup lighting turns on and the appliance froths the milk in your cup.
☛
If the preparation has been started too early or by mistake, the procedure can
be cancelled with the Exit button (4), or some settings can be changed during
the procedure. The changed setting will be displayed as blinking.
Note: The standard settings can be changed according to your taste in the «Settings»
menu point, so that they will no longer have to be adapted in the Main menu (see
Point 3.8).
3.5 Drawing hot water
Turn the Control button (2) to the symbol In the Main menu:
The standard factory setting of 150 ml is displayed in the bottom row.
• Place a cup slightly to the left under the outlet (5). Ensure that the cup is large
enough.
• Press the Control button (2) once.
• The cup lighting switches on and hot water runs into the cup.
☛
The quantity can be changed during the preparation by turning the Control
button (2), or can be set to the desired amount previously using the > button
(3) and turning the Control button (2) to the desired amount.
☛
The procedure can be cancelled at any time by pressing the Exit button (4).
3.6 «My coffee»
By programming «My coffee», you have an additional option for preparing exactly the
coffee of your choice with a single press of a button.
☛
We would advise you to first carry out the standard programming according to
your wishes before you prepare the first cup of coffee. Proceed as follows:
Turn the Control button (2) to the symbol in the Main menu:
• Press the Control button to confirm.
• Turn the Control button to «Coffee recipes» and press to confirm.
48
Hot water
Settings