• Turn the Control button (2) until the desired proportion of coffee is displayed (in
percent).
• Press the > button (3). The number of cups blinks.
• Turn the Control button (2) to 1 or 2 cups.
• All the settings will be stored by pressing the Exit button (4).
• Press the Control button once.
• The cup lighting turns on and the appliance prepares the desired coffee.
☛
If you press the Control button while you are in the standard settings, a coffee
will be immediately prepared.
☛
Y ou can return to the Main menu from the Settings at any time using the Exit
button (4). The changed settings will be retained.
☛
If the preparation has been started too early or by mistake, the procedure can
be cancelled with the Exit button (4), or some settings can be changed during
the procedure. The changed setting will be displayed as blinking.
Note: The standard settings can be changed according to your taste in the «Settings»
menu point, so that they will no longer have to be adapted in the Main menu (see
Point 3.8).
3.4 Drawing warm milk
Using the special frother, the milk will be automatically drawn from the milk cooler and
be filled into the cup.
• Fill the milk cooler with milk, close the lid and connect the suction hose (Fig. A).
• Connect the other end of the suction hose to the connection (8a).
☛
The milk can also be drawn directly from the milk carton. To do this, immerse
the hose in the carton.
TIP: Dried milk residues are very difficult to remove. You should therefore clean every-
thing thoroughly once it has cooled down! Always follow the instructions in the display
«Rinsing the frother» (see Chapter 5.1).
Turn the Control button (2) to the symbol in the Main menu:
You will see the standard factory setting in the bottom row:
If the standard setting corresponds to your requirements:
• Place a cup under the outlet (5).
• Press the Control button (2) once.
• The cup lighting switches on and the appliance froths the milk in your cup.
Warm milk
Total amount milk / proportion of foam
47