Note:
The standard settings can be changed according to your taste in the «Setting» menu
point, so that they will no longer have to be adapted in the main menu (see chapter 3.8).
3.4 Drawing warm milk
The special frother automatically draws the milk from the carton or the milk contain-
er and fills the cup.
• Immerse the hose into the milk carton or the milk container and connect the other
end of the suction hose to the height-adjustable spout (fig. A).
In the main menu turn the right control knob (3) to the position «Milk».
In the lower line the standard setting of the milk quantity is displayed in ml.
TIP:
Dried milk residues are very difficult to remove. You should therefore clean everything
thoroughly once it has cooled down! Always follow the instructions in the display
«Rinse frother» (see chapter 5.1).
If the standard settings corresponds to your requirements:
• Place a cup under the outlet (4).
• Press the right control knob (3) once.
• The appliance froths the milk in your cup.
If you want to change the standard settings:
• Turn the left control knob (2) until the desired quantity of milk is indicated.
• Press the right control knob (3) once.
• The machine prepares the milk.
☛
If the preparation has been started too early or by mistake, the procedure can
either be cancelled by pressing the right control knob (3), or some settings can
be changed during the procedure. The settings that can be changed are indi-
cated by blinking and are changed by turning the left control knob (2).
Note:
The standard settings can be changed according to your taste in the «Setting» menu
point, so that they will no longer have to be adapted in the main menu (see chapter 3.8).
3.5 Drawing hot water
In the main menu turn the right control knob (3) to the position «Water».
In the lower line the standard setting of the water quantity is displayed in ml.
If the standard setting, corresponds to your requirements:
• Place a cup under the outlet (4).
• Press the right control knob (3) once.
• Hot water runs into the cup.
46
13_0944_ROT_BA_U2762CH_IH.indd 46
13_0944_ROT_BA_U2762CH_IH.indd 46
14.10.13 09:37
14.10.13 09:37